The back of the propeller hub is glued with a cap on the inside of the nose, which was a bit fiddly to get in place. Once that was done, it was quite easy to glue the nose in place. Fit is very good so no problems there.
Once that was done I test fitted the wings, which had a very tight fit.
There’s a slight gap on the topside, but a little pressure while glueing will close that gap quite nicely. I might need some putty to close up the last teeny wee bit, but that’s all!
A few bits more and I can soon start thinking of masking glass and laying a cote of primer.